すべてのメッセージ

MCgamingPro It might be the PSU’s fault. If you are also using a heated bed at the same time, the current draw may be too much and the voltage may be dropping, causing the reboot. If you have a multimeter hook it up to the PSU and check the voltage when turning on both extruders

2021-02-23 01:46:45 役に立つ (1)
提出
回答 (5)

MCgamingPro It does not refill the propane container, it fills airsoft guns with propane

2021-01-31 09:54:22 役に立つ (0)
提出
回答 (1)

Q: Is this cable compatible with the Ticwatch E?

尋ねた MCgamingPro に 2017-12-18 04:10:11

Da7m Ask support team

2020-01-26 01:21:16 役に立つ (0)
提出
回答 (1)