jj604
私のコンテンツ
すべてのメッセージ
レビュー
コメント
回答
質問

すべてのメッセージ

jj604 28/11/2019
If you have an analog voltage input on a flight controller or telemetry receiver this is a very neat current sensor that adds virtually no weight since it also the ESC power connector. For example with an FrSky receiver that has an A1 or A2 analog input you can display the current as an equivalent voltage. 50Amps actual current = 5.00V on the display when using a scaling factor of 20.5 on my D8R Plus receiver. It is a simple device using just a 0.5mOhm sense resistor and an op amp to amplify the voltage.At high currents it has a bit of thermal drift because it gets warm but it is surprisingly linear up to 80 Amps and the offset is only about 1 Amp. The first picture shows the actual output voltage vs. current tested on an accurate constant current variable load. The second shows the Taranis A2 telemetry display value vs. current when the scale factor was 20.5 and the offset set to -0.63 on my X9D Plus transmitter. In practice it's a simple way to monitor the current as you just multiply the display voltage by 10x mentally. Not quite as straightforward as a true FrSky telemetry current sensor, and you cannot use the calculated consumption function - but it's a lot lighter and cheaper.
FullSpeed FSD AMASS XT60 カレントセンサーカレントメーター 2-6S 80A RCドローン FPVレーシング マルチローター用
US$10.99 US$13.99
7
推奨事項
コメント (0)
jj604 31/07/2019
This is neither a 50mAh cell nor a high rate cell suitable as a LiPo flight pack for most indoor planes (despite the convenient connector). It arrives very well protected in an individual plastic box and the assembly is good quality, but the test results are disappointing. This is a 42mAh cell at best and ONLY if you keep the discharge below 100mA. It will be fine for very small low load applications like the Plantraco Carbon Butterfly or the TY Model Indoor Airplane Hummingbird Ultra Light. Anything much over that and it will not performs well. At a 200mA discharge which is only a 4 C rate, this cell falls to 3.3V at mid discharge. At 100mA discharge it does fine and hold s 3.6V at mid discharge.
3.7V 50mAh 1S ミニLiPo バッテリー Molex 2P 1.25mm コネクター 10mm 1.55g Tygzs M1 KFPLAN KF606 Vapor RC航空機用
US$8.99 US$10.79
5
推奨事項
コメント (1)
2 IN 1 PGパラレル充電ボードXT30 XT60プラグ 4パック2-8S Lipoバッテリー対応
US$13.99 US$16.99

Q: How can this board do 2-8S? It only has 7 balance wire connections for up to a 6S pack?

尋ねた jj604 に 2018-08-06 07:18:26

yudhieldin itonly provides 6 cells. an explanation error occurred

2021-01-19 07:03:56 役に立つ (0)
提出
回答 (1)
jj604 02/11/2021
Conclusions: 1) The labelling at 600mAh is JUST acceptable. These cells do deliver 600mAh to a 3V cutoff at a very small 100mA load. The red line. This is about as generous a test as you can do but they do just scrape in. 2) In practical terms they are really a 500mAh cell. At a 1.5Amp load which is a 2.5C rate for a nominal 600mAh cell they have dropped to 3.35V at the 500mAh discharge point. The blue line. 3) They are fairly described as a 5C rate cell, not 25C as on the label. The green line. At 3 Amp continuous discharge they have dropped to 3.5V at 200mAh discharge and barely 3.2V at 500mAh discharge. Allowing for some small voltage drop in the test leads I would be prepared to call these cells 5C - that is 3Amp maximum discharge.
Eachine　QX95 QX90 E30 E30WシマX5-15 X5C X5SW-1 H5C 1〜4 3.7V 600MAH　アップグレードバッテリ
US$21.99 US$26.99
6
推奨事項
コメント (4)
jj604 01/12/2021
Great little vehicle. Lots of fun and fast. The kid loves it. At the discount price of less than US$ it was an absolute bargain. Very quick delivery as well. 10 days from ordering to the door in Australia.
Eachine EC07 RCカー2.4G 4CH スタント ドリフト 変形 リモートコントロール ロック クローラー ロール フリップ キッズ ロボット 自動おもちゃ
US$12.99 US$35.99
0
推奨事項
コメント (0)
jj604 23/11/2021
Good value. The XT connectors are clones, not original AMASS, but this does not matter in this application.
XT30 1S-3Sプラグパラレル充電ボード、IMAX B6 ISDT XT60プラグ充電器用
US$12.99 US$15.99
0
推奨事項
コメント (0)
jj604 01/07/2021
This is a neat little LED switch. It has a JST-XH connector on the end to plug directly to a 3S LiPo balance lead for power. You could have a separate battery or just use your main 3S LiPo since its balance lead is along for the ride and doing nothing. The switch controls 3 separate outputs for 12V LED lights. The full 3S voltage is supplied to the LEDs so your LiPo does not get out of balance. One of the servo leads goes to a channel with a 2 position switch and turns the LEDS on and off. The second goes to a channel with a 3 position switch and selects the 3 different light modes: constant on, all 3 flashing, each flashing in turn. The picture shows which lead is which - they are not marked. Switching occurs off/on at 1800uS and modes are Constant <1100uS, Flashing 1100-1800uS, Sequential >1800uS. If you have only one free receiver channel you can connect both servo leads together but you will only get off and sequential flashing. The output control FETS are Si2302DS which are rated at 20V and 2.5A but only 1.25W. Because they are 3 independent circuits you can use 1, 2 or 3 LEDs as suits. Three 12V, 10Watt LEDs seemed to be fine when flashing. 12V, 10W LEDs are well within both the voltage and current ratings but not the power rating. I suspect the whole thing will die if you kept them on continuously, but flashing is fine. The unit is nicely built as well.
RCモデル用の11.1V 3S LEDライト制御ワイヤーケーブル
US$9.99 US$11.99
0
推奨事項
コメント (0)
jj604 20/06/2021
Excellent quality precision machined gimbals with adjustable travel limits 38-54°. Was not worth the money for me as the standard gimbals are extremely good and for general fixed wing flying there is no significant difference. For quads and precision flying would be an improvement I think.
FlySky FS-HZCZ03-ADJ メタルホールロッカーアセンブリシート可変ストロークリモートコントロールホールアセンブリPL18およびNV14用
US$100.99 US$121.99
0
推奨事項
コメント (0)
RCモデル用の11.1V 3S LEDライト制御ワイヤーケーブル
US$9.99 US$11.99

Q: No - not the voltage rating, the current rating. Thanks

尋ねた jj604 に 2021-06-16 08:22:21

Jarppi01 Only the parameters of the rated voltage

2021-06-17 05:36:52 役に立つ (1)
提出
回答 (1)
5-24VミニカラフルLEDコントローラーライトモジュレーター RCモデル用
US$6.99 US$8.39

Q: What is the total current rating for this switch?

尋ねた jj604 に 2021-06-16 12:49:41

Jarppi01 2A

2021-06-16 10:29:36 役に立つ (1)
提出
回答 (1)
RCモデル用の11.1V 3S LEDライト制御ワイヤーケーブル
US$9.99 US$11.99

Q: What is the current rating of the switch.

尋ねた jj604 に 2021-06-16 12:38:54

The seller 11.1V

2021-06-16 03:55:41 役に立つ (0)
提出
回答 (1)
jj604 16/03/2021
Excellent display. Works well.
LEDミラーアラームクロック 大画面 温湿度表示 ラジオおよび時刻投影機能付き 電子時計 充電式
US$32.99 US$37.99
0
推奨事項
コメント (0)
MELROSE S101.0インチ450mAhBluetooth最小MP3音楽電話耐衝撃性フィーチャーフォン
US$25.23 US$27.83

Q: Are there any instructions in English anywhere?

尋ねた jj604 に 2018-03-13 09:44:22
提出
回答 (0)

あなたは専門家です、あなたは助けることができますか？

招待メールを購読することを心から歓迎します！

購読すると、製品に関する質問に答えるために電子メールで招待されます。購読すると、「役立つバッジ」も獲得できます。プライバシー設定ページでいつでも登録を解除できます。

他の人を助け、幸せになりましょう！

  • 申し込む

バッジについて

バッジはコミュニティに関連しており、ユーザーは質の高いコンテンツを作成したり、ミッションを完了したり、特別なアクティビティに参加したりすることでバッジを獲得します。特定の人には独自の専用バッジもあります。
CEOバッジ

CEOバッジの所有者はバングッドのボス。

獲得できるバッジはまもなく提供されます
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe