招待メールを購読することを心から歓迎します！
購読すると、製品に関する質問に答えるために電子メールで招待されます。購読すると、「役立つバッジ」も獲得できます。プライバシー設定ページでいつでも登録を解除できます。
他の人を助け、幸せになりましょう！
すべてのメッセージ
giggi99
10/03/2021
I searched for a good printer (my first printer) at a low budget and it is quite impressive how good it works ... the packaging is very good, the printer itself is quite easy to install and use .
I used tingiverse file and cura for slicer it have the correct preset for the printer (only printhead settings for sequential printing are incorrect)... I started with the test cube included in the USB pen, it sticked too hard to the hotbed and bad layer adhesion (the pla I got needed higher temperature I found It out later when I printed a temp tower) results braking it also ecause there is no spatula included !!! no test filament included so buy it if you whant to use your new printer 🤣 some minor imperfections in plastic parts but unnoticeable and doesn't influence the hardware... so as my absolute first 3d Printer and totally new in this world I can definitely suggest to buy this printer! I am really satisfied with it and enjoying the learning progress... btw first 2 weeks owning it has been a non stop testing and printing ✌🏼 I included a picture of the hotbed rails I printed because it could be usefull to prevent hot bed cable braking it is a good way to learn sequential printing when you need many parts in one print ;)
Artillery® GeniusPro＆Genius3Dプリンター220*220*250mmプリントサイズ、超静音ステッパーモーターTFTタッチスクリーンサポートフィラメントランアウト電源障害機能
US$300.00
US$567.57
7
推奨事項
コメント (2)
giggi99 ciao ho ordinato dalla Spagna mi pare ... ora non lo vedo più disponibile
giggi99
10/03/2021
7
コメント (2)
giggi99
10/09/2018
