招待メールを購読することを心から歓迎します！
購読すると、製品に関する質問に答えるために電子メールで招待されます。購読すると、「役立つバッジ」も獲得できます。プライバシー設定ページでいつでも登録を解除できます。
他の人を助け、幸せになりましょう！
すべてのメッセージ
ricbrag
20/04/2022
A little bit trickier to assemble (the instructions are not very clear) but after a few attempts I finally figure it out. This YouTube video could help (https://youtu.be/8YIPKHZnk5w) it is not the same model, but the assembly is the same. The product works perfectly. Not sure if it has a true 5500 mW output. I was able to engrave some cardboard using a single pass with 30% power at 1000 mm/s speed, but it took 4 passes to cut a 1.5mm thick post-it pad using 100% power and 1000 mm/s speed. The cut was very sharp.
TWO TREES® TOTEM S 40Wレーザーエングレービングマシンフレームキットレーザーエングレーバー圧縮スポットLD+FAC 5W 5.5W高速高精度プリンタレーザーカッターメタル木材ステンレス鋼用
US$329.00
US$437.99
4
推奨事項
コメント (0)
Q: Is this compatible with NVMe?
尋ねた ricbrag に 2022-05-03 07:47:31
geogil73 Possibly NO. The nvme card fits ito the socket but it askw for initialisation. I tried 2 M.2 nvne cards. Just the same. Take care , if you answer "Yes" all your data will be gone!
2022-07-05 05:14:28 役に立つ (0)回答 (1)
尋ねた ricbrag に 2022-05-03 07:48:21
george7n yes, it fits a 2280 card
2022-06-25 12:52:11 役に立つ (0)回答 (1)
尋ねた ANGEL に 2021-12-19 11:10:31
ricbrag judging by the price... probable no...
2022-05-03 07:50:17 役に立つ (0)回答 (1)
Q: Is this compatible with NVMe 2280 ?
尋ねた ricbrag に 2022-05-03 07:45:55回答 (0)
Q: Can it monitor 5 tires (front, rear, and spare)?
尋ねた ricbrag に 2020-11-09 01:48:13
Zerrenner No, unfortunately there are only four caps with sensors, and the device has no setup to an extra tire.
2020-11-09 02:03:24 役に立つ (1)回答 (6)