招待メールを購読することを心から歓迎します!
購読すると、製品に関する質問に答えるために電子メールで招待されます。購読すると、「役立つバッジ」も獲得できます。プライバシー設定ページでいつでも登録を解除できます。
他の人を助け、幸せになりましょう!
招待メールを購読することを心から歓迎します!
購読すると、製品に関する質問に答えるために電子メールで招待されます。購読すると、「役立つバッジ」も獲得できます。プライバシー設定ページでいつでも登録を解除できます。
他の人を助け、幸せになりましょう!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
MikeRoberts Sorrythese do not work direct with a Raspberry Pi. I made the comment above after driving a PT2314 on a JBL on-time direct with no problems. The problem with the modules relates to their ability to pull the data line low to give the ACK I2C notification. The chips on the two modules I bought had a weak pull down (to only around 1/3V) and hence the Pi did not see this and terminated the transmission. The modules did work with an Arduino Uno that has a lower pull down current (around 0.5ma) compared to the Pi that takes 2ma. So in broad terms these should work with 10k pullup resistors but are unlikely to work with pull-up resistors of 3k3 or less. I normally use 3k3. An I2C voltage level converter should provide adequate pull-down to drive the Pi and may have a low enough pull-down current for the PT2314 modules. Also these modules have 1k resistors in series with the data and clock inputs. These should not be there and make the situation worse. Hence best to short these out (R11 and R12). Mike