招待メールを購読することを心から歓迎します！
購読すると、製品に関する質問に答えるために電子メールで招待されます。購読すると、「役立つバッジ」も獲得できます。プライバシー設定ページでいつでも登録を解除できます。
他の人を助け、幸せになりましょう！
すべてのメッセージ
BG346351252
05/07/2022
Machine came only with assambly instructions, no drivers, no software, no further informations about the controller board.
setting up the machine was a trial and error game to find out the steps per mm ratio you need to configure the machine / software.
The machine still uses GRBL 0.9 an quite old firmware.
Also the machine came with the wrong plug and a not excangeable power wire. so i had to bought an adapter for german power outlets.
アップグレードされた3018 Pro CNCルーターオフライン彫刻家DIY 3軸GRBL彫刻マシン木工ルーター
275,85€
460,36€
0
推奨事項
コメント (0)
Q: Can I daisy chain several of these? By just connecting output of the first with input of the next?
尋ねた halvorkise に 2019-07-26 02:27:41
BG346351252 Depending on how much you want to daisy chain you should inject supply power every 2 or 3 modules else the voltage drop and the current running through the modules gets to high
2021-05-02 11:14:19 役に立つ (3)回答 (5)
BG346351252
18/03/2021
BG346351252
18/03/2021
BG346351252
18/03/2021
BG346351252
18/03/2021
BG346351252
18/03/2021
尋ねた kurumin2016 に 2020-08-13 07:53:04
BG346351252 Mine came with 230v EU (German) power cord
2021-03-18 08:14:15 役に立つ (0)回答 (14)
尋ねた BG442043178 に 2021-02-27 07:37:44
BG346351252 Theboard is completly assambled except for the pin-headers used for the connection. Those have to be soldered by yourself
2021-03-05 04:35:42 役に立つ (0)回答 (8)
Q: For full circle you need 4 pieces?
尋ねた BG346351252 に 2020-10-01 03:48:23
Kekuj correct
2020-10-11 08:28:08 役に立つ (0)回答 (1)