すべてのメッセージ

Q: what prop for Modula7 V2?

尋ねた BG142313533 に 2020-06-12 07:58:53

Christian Not these. These are for the 65mm size whoops. They will fit but won’t perform well.

2022-09-28 09:16:22 役に立つ (0)
提出
回答 (2)

Wes Youselect LH or RH to match your VTX antenna (RHCP TX to RHCP RX or LHCP TX to LHCP RX). Each port on the screen is an independant RX so you can put it in either connector. The best way to use this "diversity receiver" setup is a directional "beam" type in one, and an omni-directional antenna in the other. The beam type must be pointed at your craft TX antenna, and the omni-directional will work in basically all directions (all antennas do have some small null areas to keep in mind).

2020-07-02 09:03:09 役に立つ (0)
提出
回答 (1)

Q: RTF or DIY assembly? receiver included?

尋ねた BG142313533 に 2020-06-02 11:04:01

kirilhk Its diy but the only soldering you do is the motors and receiver and they are easy to solder, so its basically an easy job to assemble it

2021-10-30 12:48:24 役に立つ (0)
提出
回答 (2)

Q: what camera do you recommend for this? do you sell it? Batteries?

尋ねた BG142313533 に 2020-06-04 02:30:13

Flarfwas C5830 Camera, but inavailable now.

2020-07-06 04:08:13 役に立つ (0)
提出
回答 (1)

Dobbyman_69cx What antenna you used on transmitter? If it is RHCP, you should use RHCP same type antenna on Hawkeye little pilot 4.

2020-07-04 01:14:34 役に立つ (0)
提出
回答 (1)

Nera87 Hi, check cable inside and scan with your goggles to get the right frequency! Let me know, take a look at YouTube Nera87 Hope this help

2020-07-02 08:11:41 役に立つ (1)
提出
回答 (1)

Q: needs a camera and a receiver? what else?

尋ねた BG142313533 に 2020-06-08 09:33:32

Thisred Yes , you also need a camera , a receiver, a vtx module, a lipo battery, radio transmitter

2020-07-02 07:19:17 役に立つ (0)
提出
回答 (1)