招待メールを購読することを心から歓迎します！
購読すると、製品に関する質問に答えるために電子メールで招待されます。購読すると、「役立つバッジ」も獲得できます。プライバシー設定ページでいつでも登録を解除できます。
他の人を助け、幸せになりましょう！
すべてのメッセージ
daveneky@email.cz
07/11/2018
daveneky@email.cz
15/08/2018
daveneky@email.cz One note check connection ribon cable on the board accordin to this link: https://goo.gl/PoGg1T
Headchopper
17/06/2018
0
コメント (3)
daveneky@email.cz One note check connection ribon cable on the board accordin to this link: https://goo.gl/PoGg1T
Juanma80
17/06/2018
0
コメント (4)
daveneky@email.cz
23/04/2018
daveneky@email.cz
22/01/2018
Q: I am sorry but I am not able to bind it with Q X7. Is there some advice how make it succesfully?
尋ねた daveneky@email.cz に 2017-12-22 04:28:56
Lalomendez Hello, first you need to configure receiver mode D16, in the page setup and start binding. In the receiver there is a little button in the corner (very hidden), you must press it while connect the power supply, in this moment two small led will power on (red and yellow). Disconnect the power supply from drone and exit from binding mode. Connect again the drone. Sorry for my bad english. NOTE: The trick is the binding button almost hidden in the receiver. Cheers.
2017-12-29 05:29:51 役に立つ (0)回答 (1)
Bison008can they have a protective coating on both sides. being led they dont get warm at all
2021-10-13 11:30:06 役に立つ (0)