すべてのメッセージ

DanSourmayo I don't believe so. This isn't the same as the microcontroller on the control board for that engraver. I'd suggest replacing the entire control board, as you'd have to find the correct microcontroller and find and flash the correct (potentially proprietary) software onto it.

2022-02-10 12:52:30 役に立つ (0)
提出
回答 (3)

DanSourmayo Not a direct answer, but I ordered a 2 pin euro adapter to the UK and they supplied a euro to UK adapter. The UK plug is seldom in stock!

2021-08-20 03:38:14 役に立つ (0)
提出
回答 (3)

Q: which is the Amp suported?

尋ねた weisy に 2019-01-23 09:57:56

DanSourmayo I have used up to 1.5amps without an issue. If you have a bench supply, you could sacrifice one connector and test how many amps it could handle.

2021-08-20 03:35:58 役に立つ (0)
提出
回答 (2)

DanSourmayo You can add one colour at a time, and as many of that colour as you want, to your cart. So you can add two red to your cart, then add one yellow to your cart.

2021-08-20 03:32:38 役に立つ (0)
提出
回答 (5)

Q: Is there soft rubber tyres in each car instead of foam tyres ?

尋ねた BG644127836 に 2021-03-30 08:37:28

DanSourmayo There is not an option for rubber tyres, though some other models do have rubber tyres.

2021-08-20 03:31:24 役に立つ (0)
提出
回答 (7)

DanSourmayo You could solder a small resistor or potentiometer between the motor and board. You'd want to start by figuring out the number of volts the motor uses and calculate what resistance you should need to drop the voltage slightly.

2021-08-20 03:30:21 役に立つ (0)
提出
回答 (11)