招待メールを購読することを心から歓迎します！
購読すると、製品に関する質問に答えるために電子メールで招待されます。購読すると、「役立つバッジ」も獲得できます。プライバシー設定ページでいつでも登録を解除できます。
他の人を助け、幸せになりましょう！
すべてのメッセージ
sam1301 I’m not sure there is a blink sketch to blink the blue LED as it’s actually linked to the AXP charge chip and not the ESP32 chip. It may be possible if you can instruct the AXP chip to turn on and off the LED but it usually comes on by itself when charging a battery.
2020-03-22 03:02:40 役に立つ (0)回答 (2)
sam1301
24/01/2020
Q: Well how does this work then. Is it a pencil.?
尋ねた kevin_flett に 2020-01-10 02:58:10
sam1301 I would compare it more to a pencil myself but instead of graphite for the lead it uses a alloy mix that doesn’t wear down like a normal lead pencil. And cannot be erased with a rubber More info can be found by googling ‘ink less pen’
2020-01-12 03:53:03 役に立つ (3)回答 (2)
Q: how can I set the dmx Adress of it
尋ねた NoJo042 に 2019-02-18 02:31:11
sam1301 It is done automatically when the units are ‘daisy chained’. There are guides online t manually program using the four solder eyes as they are a serial port.
2019-12-03 05:36:06 役に立つ (0)回答 (2)
Q: how to set dmx channel ?...
尋ねた freds に 2019-08-10 02:18:28
sam1301 I’ve got these but from another source. The DMX addressing is done automatically by the units being ‘daisy chained’. I’ve sen guides online to program the addresses manually via the four solder eyes in the middle of the pcb as it’s a serial port for programming.
2019-12-03 05:34:32 役に立つ (0)回答 (2)
sam1301 Normally Closed. (Open valve when 12v-24v applied, closed when no voltage applied)
2020-08-13 06:04:18 役に立つ (0)