招待メールを購読することを心から歓迎します！
購読すると、製品に関する質問に答えるために電子メールで招待されます。購読すると、「役立つバッジ」も獲得できます。プライバシー設定ページでいつでも登録を解除できます。
他の人を助け、幸せになりましょう！
すべてのメッセージ
尋ねた Filek に 2021-05-12 05:17:11
回答 (4)
Filek
23/03/2022
Filek
23/03/2022
Filek
23/03/2022
Filek
23/03/2022
Filek
23/03/2022
Filek
23/03/2022
Filek
23/03/2022
Filek
23/03/2022
Filek
23/03/2022
Filek
23/03/2022
尋ねた joseqfneto に 2020-01-29 07:40:28
Filek No! It will lower the 14.4 volts to 12v, but it will NOT raise the 10.5v up to 12v
2022-02-25 07:28:57 役に立つ (1)回答 (6)
Q: Can I plug this directly into the ender 3 or do I need to change the firmware?
尋ねた Meebert に 2020-08-18 05:32:40
Filek It doesn’t fit in the stock Ender 3 pro heater block
2022-01-30 07:18:54 役に立つ (0)回答 (5)
Filek
14/08/2021
Filek
06/12/2021
尋ねた jflb01 に 2020-01-28 01:06:21
Filek The Ender 3 pro has the same Bowden tube setup, with same hot end and extruded and would have the same difficulty printing TPU as regular Ender 3
2021-12-05 06:17:13 役に立つ (0)回答 (3)
Filek
05/12/2021
尋ねた marwan に 2018-06-04 11:49:57
Filek Yes, it would work, but I would keep the glue to the screen edges. The glues is clear, but might have a slight cloudiness. A much better glue would be the UV cured resin for screen repair.
2021-12-05 06:14:23 役に立つ (0)回答 (1)
BG245618134 contact the customer support.
2022-04-11 06:28:40 役に立つ (1)