すべてのメッセージ

stevietee10 Yes, to change direction of rotation just reverse (swap) any two motor wires, any two, doesn’t matter which 😀

2022-05-23 09:11:47 役に立つ (0)
提出
回答 (3)

stevietee10 You need goggles or a monitor to view this camera, usually with video transmitter and receiver system. It does not record but you could add a video recorder board which would save video to an SD card

2022-01-26 08:13:31 役に立つ (0)
提出
回答 (3)

Q: Will a 4s 5000mah lipo fit in this?

尋ねた BATAN に 2021-10-15 01:17:13

stevietee10 YES, a Turnigy Multistar 4S 5200mAh, the green one :-), fits perfectly in the S1100 front battery bay.

2021-10-22 07:08:08 役に立つ (0)
提出
回答 (2)

Q: can i use it with a flysky transmiter?

尋ねた BG454817151 に 2021-09-19 01:15:25

stevietee10 Yes, just use a radio receiver that is compatible with your transmitter 🙂

2021-09-19 02:31:58 役に立つ (0)
提出
回答 (3)

stevietee10 Yes, same battery, has a link harness to share battery between goggles and receiver bay. It works well 🙂

2021-04-08 12:34:51 役に立つ (0)
提出
回答 (1)

Q: Funciona com DJI NAZA / DJI Wookong / DJI A2?

尋ねた rodrigao2010 に 2021-02-20 08:53:04

stevietee10 No, this will not work with DJI controllers DJI use a single proprietary serial connection for both GPS and compass. This BN-180 unit only has a GPS outputting a raw serial data stream, no compass

2021-02-21 04:10:01 役に立つ (0)
提出
回答 (2)

Q: does battery come with saw?

尋ねた BG422452839 に 2021-02-12 02:05:15

stevietee10 No it does not.

2021-02-13 12:07:32 役に立つ (1)
提出
回答 (13)

stevietee10 These are blank plastic lens protectors, if you wear glasses they can be replaced by 'prescription lenses' for super sharp image Hope this helps, Steve.

2020-12-07 01:27:56 役に立つ (0)
提出
回答 (5)

Q: can i use this for back up battery for my motorcycle 12v battery?

尋ねた BG203854573 に 2020-10-11 02:47:33

stevietee10 NO! NO! NO! This is not a battery, it produces very high voltage which can cause severe pain or injury to a person This is what is used in cattle prods and Tazer guns !!!

2020-10-11 04:32:41 役に立つ (3)
提出
回答 (8)

Q: has any one tested on 5v or is everyone just running 3.3v

尋ねた crash0ne に 2019-09-08 10:40:52

stevietee10 Power it from 5v, it has an internal 3.3v regulator for the components that need 3.3v

2020-09-29 02:13:10 役に立つ (0)
提出
回答 (2)

Q: Can it work with F765 ardupilot?

尋ねた salim al:amri に 2020-08-30 07:30:43

stevietee10 Yes, works with Matek F765 flight controller.

2020-09-29 02:11:01 役に立つ (1)
提出
回答 (2)

stevietee10 YES it is compatible with 1.2GHz use Just install the antenna suitable for your needs. I’m using mine with 2.4GHz, others are using 5.8GHZ. Just depends on your choice

2020-09-29 02:01:50 役に立つ (1)
提出
回答 (4)

stevietee10 This will work with PIXHAWK, it has 2 wires for power, 2 wires for GPS TX/RX and 2 wires for magnetometer (compass) SCL/SDA

2018-12-30 04:35:08 役に立つ (0)
提出
回答 (1)

stevietee10 HMC5883, in Betaflight / iNav select 'MAG Alignment' at CW 270' Flip

2018-12-14 04:03:43 役に立つ (2)
提出
回答 (1)