招待メールを購読することを心から歓迎します！
購読すると、製品に関する質問に答えるために電子メールで招待されます。購読すると、「役立つバッジ」も獲得できます。プライバシー設定ページでいつでも登録を解除できます。
他の人を助け、幸せになりましょう！
すべてのメッセージ
Richard
13/06/2022
Q: Is part B the Hook or is part C the hook? Which part is Hook and which part is Loop?
尋ねた Donald に 2022-06-16 05:30:04
Richard B is loop C is hook When you add to cart and select B or C , the picture changes and the word hook and loop is shown as appropriate.
2022-09-12 07:02:36 役に立つ (0)回答 (1)
Q: What is the wattage of the amplifier? can be connected to car speakers?
尋ねた BG451823504 に 2021-07-19 07:13:25
Richard It only has signal level output. It can be connected to an amplifier which can be connected to car speakers.
2022-08-23 12:06:34 役に立つ (0)回答 (6)
Richard
13/06/2022
Richard
13/06/2022
Richard
13/06/2022
Richard
13/06/2022
Richard
13/06/2022
Richard
13/06/2022
Q: Cannot bind to my JR DSM-2 transmitter. Suggestions?
尋ねた BG133716492 に 2020-10-06 12:35:42
Richard The required protocol is V761, not DSM. V761 is available in 4in1 multiprotocol modules, as found in many but not all OpenTX transmitters. An example is the Jumper T12 Pro.
2022-01-14 07:21:59 役に立つ (0)回答 (2)
Q: Hi guys ! Is it possible to bind it why a 2.4Ghz transmitter ? Thanks
尋ねた BG184844324 に 2020-05-04 01:32:24
Richard It will bind to OpenTX transmitters like the Jumper T12 Pro. Suitable transmitters must have a 4in1 multiprotocol module. A single multiprotocol module is not sufficient because the V761 protocol is not supported by the chip used in single chip multiprotocol modules.
2022-01-14 07:18:12 役に立つ (0)回答 (2)
Q: What is the onboard 1s brushed motor speed controller rating, 1,2,3,4,5 amps?
尋ねた Anon Youse に 2022-01-13 08:17:11
Richard The V761-1 model uses a 160mAh battery and flies for about 10 minutes. So the battery capacity is one sixth of an Amp-hour and the flight time is one sixth of an hour. This reflects an average current of 1 Amp.
2022-01-14 07:14:32 役に立つ (0)回答 (2)
尋ねた siddheshsatam に 2020-09-04 10:20:51
Richard It will bind with OpenTX transmitters that have a 4 in 1 multiprotocol module. It is not sufficient to have a single multiprotocol module.
2022-01-14 07:09:23 役に立つ (0)回答 (2)
Richard
31/12/2021
Q: one glass full of tap water,and the other full of R/O water...Please explain what it means R/O water
尋ねた kitsos に 2021-09-04 02:29:18
Richard RO = Reverse Osmosis. Very very pure water.
2021-12-11 11:55:14 役に立つ (0)回答 (3)
Richard
12/11/2021
Q: Can be bind with Jumper T12 ?
尋ねた popad に 2021-02-06 10:41:17
Richard I bind them to a Jumper T12 Pro transmitter, which has an inbuilt 4-in1 Multi-protocol module. With a T12 (not Pro) I think you have to put a 4-in-1 module into the bay on the back of the TX.
2021-10-15 08:35:24 役に立つ (0)回答 (2)
Q: will this be sold as mode 1 as a lot of modlers in australia use mode 1
尋ねた unleaded に 2021-04-04 08:34:34
Richard I use them with a Mode 1 Jumper T12 Pro transmitter. That's how I got around there not being mode 1 versions of the OEM transmitters.
2021-10-15 08:30:57 役に立つ (0)回答 (2)
Richard@BOOGIE V761protocol for Volantex and Eachine. Then 4 channel sub-option. For gyro control configure 3 position switch on CH5 with settings of -100%, 0% and 100%
BG015251038
18/11/2020
3
コメント (6)
Richard JST 1.25mm pitch
2023-06-10 01:25:00 役に立つ (0)