すべてのメッセージ

The seller Dear customer, Thank you for your support and understanding. If you have any other question please contact our customer service : cservice@banggood.com freely. we need some time to ask the supplier,you can contact the live chat. They would help you.

2021-08-05 07:06:33 役に立つ (0)
提出
回答 (1)

Q: Cuántos watts de salida maneja?

尋ねた BG375315055 に 2021-07-16 02:26:07

MarkMak Specs indicate it is not a powered mixer, so it outputs line level (no watts just signal), so you must feed the output into a power amplifier or powered speaker.

2021-07-24 01:46:19 役に立つ (0)
提出
回答 (2)

Q: r these lights bright?

尋ねた troy37 に 2021-06-29 09:39:57

MarkMak Bright enough for low beam on my Merc Vito. Haven't tested them as a high beam bulb replacement. Depending on your vehicle, you may need a ballast resistor or similar in parallel on the circuit to avoid blown bulb warnings, as they are so much more efficient than incandescent bulbs the car's computer thinks the bulb must have blown. Working well for me.

2021-06-29 11:06:11 役に立つ (1)
提出
回答 (3)

MarkMak Very hard to say what the cause may be. Something to check, does it keep buzzing after the power is disconnected? If not it's own battery may be dead which might upset the item. Failing that, they are inexpensive devices, with a finite life-span, so perhaps it has just failed and needs replacing. If it is fairly new you may wish to raise a claim on the seller?

2020-08-24 08:38:43 役に立つ (0)
提出
回答 (1)

Marcos86 In the hour option press and hold the Screen until the desired option is reached.

2020-06-12 08:57:19 役に立つ (0)
提出
回答 (1)

Q: Please add the pin-out diagram to this listing.

尋ねた MarkMak に 2020-03-29 09:49:11

Fascine http://myosuploads3.banggood.com/products/20190220/20190220011125CSR8645.pdf

2020-04-03 04:46:24 役に立つ (1)
提出
回答 (1)

Q: can it useful as amplifier

尋ねた MohItWaghade に 2018-07-15 07:29:23

MarkMak No, it outputs "line level" so must the output from this receiver, must connect to the input of a separate amplifier.

2020-03-30 02:32:01 役に立つ (0)
提出
回答 (2)

Q: what is the frequency response?

尋ねた tiamendes1 に 2019-04-08 09:26:23

MarkMak Photo of rear of speaker indicates 100Hz to 20KHz

2020-03-30 12:05:23 役に立つ (0)
提出
回答 (2)

MarkMak Pushing a separate input signal to the module's output should not damage the module provided the other source is line level not headphone/speaker level, but if there is any impedance mismatch or signal level mismatch between the two signal sources, one signal will be much louder than the other. It would be advisable to build a simple signal mixer circuit using two variable resistors, or use a toggle switch to select between inputs, i.e. the BT output of this board, and 3.5 Audio input, routing single output to the Logitech Z-5500

2020-03-29 09:26:10 役に立つ (0)
提出
回答 (2)

Q: does this work with all eaching googles

尋ねた Marvin に 2019-02-04 10:17:41

MarkMak Yes,works with mine. If you have an old pair of goggles, you may need to restrict the transmitter to certain frequency bands, but you will generally be OK.

2019-09-17 06:48:58 役に立つ (0)
提出
回答 (2)

MarkMak Yes,plenty of power in this. 1.4kg thrust on all 4 motors, means you will have plenty of headroom for the FC to use to stabilise.

2019-09-17 06:47:23 役に立つ (0)
提出
回答 (1)