すべてのメッセージ

ThompTech RHP. Right Hand polarization is the default for most systems. Left hand is used when you are near a person using RHP (such as a race event) to help with interference as RHP and LHP interfere with each other less than when both pilots use RHP..

2020-03-12 10:54:55 役に立つ (2)
提出
回答 (3)

Q: This 4in*****a esc work with F3 Flight controller Acro 6DOF.?

尋ねた binh ha に 2020-02-28 10:21:58

ThompTech Yes it will. This esc will work with essentially every f3 or later board.

2020-03-12 10:50:51 役に立つ (0)
提出
回答 (2)

ThompTech The red light comes on when the unit is charging. The green light comes on when the unit is finished charging. This may indicate an issue with the battery or charging system.If the wall charger isn't working try the USB charger. If neither works that would point to your goggles having the issue. If one charger works and the other does not then its likely the charger.

2020-02-05 07:01:35 役に立つ (1)
提出
回答 (2)

ThompTech 1. Pull is same as thrust/lift in this case and refers to the grams of thrust produced at a given volt/amp. 2. This motor can run on a 3S 11.1v lipo or a 4S 14.8v lipo battery. The the 14.8v draws more amperage @ 27A and provides more pull/thrust. Hope that clears it up.

2020-01-08 04:57:41 役に立つ (0)
提出
回答 (2)

Q: what can be the minimum measured voltage for 1 cell 3V / 2.5V?

尋ねた AndrzejG22 に 2019-05-14 11:45:17

ThompTech Don't go below 3.2 volts or the charger will likely give a low voltage error and refuse to charge the cell. Also do not charge each cell beyond 4.2 volts or you risk fire and or damage to battery life.

2020-01-07 09:20:37 役に立つ (1)
提出
回答 (1)

thompson49022 If coil is not working then replacement would be based on if you are still in warranty. Check your motor manufacturer's warranty and if you are within its coverage time submit a claim and they will take care of it. I would start with warranty check and if its still in warranty get the free replacement. Otherwise, try epoxy applied with a tooth pick. Try to keep the loose coil in its original shape as much as possible then use the epoxy to hold it to the parent coil. Cheers!!

2020-01-07 09:03:04 役に立つ (0)
提出
回答 (2)

Q: Can it read ibus?

尋ねた bluehell に 2019-09-09 03:32:14

thompson49022 This particular model does NOT use iBus. It does work with SBUS, PPM, DSM and PWM signals.

2020-01-07 09:00:00 役に立つ (0)
提出
回答 (1)