すべてのメッセージ

mikelopez 1) The yellow jumper is in the corner (bottom right in the photo). A product information sheet that shows the various positions can be found at: www.mpja.com(pathseparator)download(pathseparator)31227sc.pdf 2) I don't understand what you mean by a "bridge". There are two positions for the jumper, which set pin 1 of the BISS0001 to Vdd or ground to choose H (repeat) or L (one-shot). You can find a datasheet for the BISS0001 at cdn-cdn-learn.adafruit.com(pathseparator)assets(pathseparator)assets(pathseparator)000(pathseparator)010(pathseparator)133(pathseparator)original(pathseparator)BISS0001.pdf

2021-01-16 05:44:21 役に立つ (0)
提出
回答 (1)

js_mr But also if you don't use speakerground and if there is no potential separation between the speaker signal and the protection board power supply the relays never close. I removed the relays from the board and wired only the control inputs. So I get a delayed switch on for the speakers. This is sufficient for my switch on crackle.

Dénes Pataki 29/04/2016
3
コメント (3)