Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Psyklops Hey havn't got it working with my dumborc tx, don't have the new version tx to do the right mix so using a flysky tx and rx, a delta wing mix on tx, 50% ch 1 to ch 2 visa versa, yellow into ch2 on rx and note the position of the switch on the esc, one way is single signal, other is dual which is what you want. Modified mine by cutting positive supply track to the two chips at motor plug end and applying them with raw battery voltage separate to the mcu positive power supply. That way can actually run then at our over 5 amps. The mcu detects dips in supply voltage and shuts esc down before it hits 5 amp to motor, let alone 5amps to each motor, i think chip is rated at 7a continous off top of my head. Tldr Sounds like your switch on esc in wrong position or broken, they are fragile and heatshrink makes it hard to switch. If broken your need to solder the two tiny pads of the switch together.