回答
Q: can i use to regulate the speed of a dc motor?
尋ねた BG375415825 に 2022-05-28 07:37:16
cmeng48 As long as your motor is less than 2000 watt.. it should work but talk to your electrician for proper advice. Personally this is an open item and could be dangerous if not housed properly.
役に立つ (0)
Q: Does this kit fit the rear master cylinder of a 2005 harley 883?
尋ねた Lucio に 2021-03-24 17:58:28
cmeng48 No.
役に立つ (0)Q: hi! is this item can be use for electric drill?
尋ねた zack に 2020-09-23 15:24:37
cmeng48 no.
役に立つ (0)
Q: Can it be used on mild steel?
尋ねた viking61 に 2021-10-12 08:30:37
cmeng48 Hi viking61, I am a machinist long time ..No it cannot be used on mild steel they are dissimilar metals. For mild steel use silver brazing rod with at least 40% silver and a brazing flux for a strong joint or repair. Hope this helps.
役に立つ (1)
Q: Is the Dremel 3000 compatible?
尋ねた weyselkalkan に 2021-07-09 17:19:28
cmeng48 What do you mean?.. if you are asking if the dremel tool is to be used as a tool for gear cutting then no! Gear cutting requires a lot of experience in machining and a lot of machine tools. I hope this helps.
役に立つ (1)
Q: Is it solar energy dependent? will it work at night?
尋ねた GKM に 2019-12-20 01:59:28
cmeng48 Itshould work at night but not sure cause I don't weld at night.
役に立つ (0)
Q: When would a Module 1 PA20 Bore 22mm "5" HSS Involute Gear Milling Cutter be available. thanks.
尋ねた BG445191415 に 2021-05-14 20:25:34
cmeng48 Iam only a buyer..so I don't know. Try Aliexpress.com if you are in a hurry.
役に立つ (0)
cmeng48 Yesit can be used for aluminum..all carbide end mills can.
役に立つ (0)