回答
Q: what is the firmware version and how can it be upgraded?
尋ねた BG573216171 に 2021-03-02 20:34:13
Q: i cannot use in 30a circuit breaker?
尋ねた BG135501148 に 2021-09-01 01:17:00
mainframe You can. I am on a 16amp breaker and use this quite a bit. I usually go up setting 6 or 7 (current dial) because the wires do get hot if use it for a larger amount of welds. A few days ago i did a 5s16p pack on setting 6 with ~12 pulses and i had to let the welding wires cool down because they were too hot to hold comfortably.
役に立つ (0)
Q: what size is the prop hub shaft? 5mm? 6mm?
尋ねた Andy0679 に 2021-08-08 17:43:55
mainframe 5mm on the SunnySky x2216-7 1400kv that was included in the pnp kit
役に立つ (1)
mainframe they can work, it depends on the motor inside the shutter though.
役に立つ (0)
mainframe They will not grow to be like the picture suggests, in fact it's very unlikely that they will even germinate.
役に立つ (0)
mainframe technically it should. the voltage range covers eu and us. I think what eu refers to in this case is the size of the device as it fits perfectly into a European wall socket.
役に立つ (0)
Q: will this work with an inductive sensor?
尋ねた jere69420 に 2020-04-12 19:51:06
mainframe Not the top layer no, as an inductive sensor relies on metal. A bltouch is not an inductive sensor, it is a touch sensor. Inductive and capactive sensors can detect surfaces without touching. In short, i would not recommend an inductive sensor with this as the results can be unreliable.
役に立つ (1)
mainframe Yes, it can be upgrade by using Flash Multi (github, and the instructions on the website). This will rewrite the bootloader and a firmware of your choosing. i.e. aircraft, land etc. That's the easy way I found.
役に立つ (1)