回答
Q: Hi.. What sizes are the shanks on these and are they upcut spiral? Thank you
尋ねた BG441381137 に 2022-05-21 13:35:55
v8rick shank same size as cutter , see table in description
役に立つ (0)
v8rick Not used for that. Use some one handed ratchet clamps cheaper and available everywhere. most are reversable clamp or separate
役に立つ (1)
v8rick Zero anywhere you like. I use this as bench not level so I can set on saw then check blade
役に立つ (0)
Q: what size dog hole will these clamps fit?
尋ねた maxvacchio に 2019-06-17 07:33:34
v8rick standard20mm holes
役に立つ (0)
v8rick No just base Base. I attach using base then zero device
役に立つ (0)
Q: Hi, can this fit the smaller T track
尋ねた BG453744502 に 2021-06-15 22:27:20
v8rick You would have to replace bolts on adjuster with T bolts there are 4
役に立つ (0)
Q: Where can I find slot nut for this Track?
尋ねた Ábraham Péter に 2021-12-06 05:02:02
v8rick I use the 6mm and 8 mm T bolts that came with clamps off here. DrillPro Aluminium Alloy T-Track Hold Down Clamp with Slider Woodworking Tool
役に立つ (0)
v8rick Youjust get the center part ( camera not the outer IR parts
役に立つ (0)