回答
Q: How can this unit support 24Vdc when the smart relay from Wangll is marked 14Vdc?
尋ねた BG171536131 に 2022-02-01 17:10:18
Q: what is the diameter of the marking end of the pencil, not the refill’s.
尋ねた BG561844816 に 2023-11-25 14:34:39
FondofBlondes About 5.8 mm, so the hole of your guide or ruler needs to be at least 6 mm in diameter. The length of the tip is 40 mm, excluding the length of the protruding lead.
役に立つ (0)
Q: Can display be turned off ? Thanks.
尋ねた oz_pekeren に 2021-05-19 21:35:12
FondofBlondes If you are asking if the display can be switched off and still measure AHr or WHr, the answer is no. You can add a separate switch to disconnect the power to the meter which will switch off the display but that kind of defeats the purpose of the unit.
役に立つ (0)
Q: is this available in Metric size
尋ねた Antgeebee に 2020-06-28 05:07:03
FondofBlondes This set is not available in Metric size. You can get other Step Drill Bit Sets in Metric size. I will need to look elsewhere like Wish or AliExpress.
役に立つ (0)
FondofBlondes Already stated in description - from 0.5 to 4 mm square. Although I personally would not run anything more than 20A through that connector. A 4 mm square can handle 60A at 230V.
役に立つ (0)
FondofBlondes I measured 26 mA and I am sure most of it is to power the display.
役に立つ (0)
Q: What is the 2 pin connector on the bottom edge? Right below the "KWS-DC200"?
尋ねた Don に 2020-12-31 13:43:11
FondofBlondes To measure temperature with the included sensor.
役に立つ (0)
FondofBlondes The relay is rated at 14V and 20A DC, so if you double the voltage then halve the current and you should be fine.
役に立つ (0)