回答
Q: Can you put it next to the X6B receiver from flysky? (I mean on the same level of the stack)
尋ねた Fufs に 2018-09-29 13:11:05
Raqtor This is bigger than a half stack so you would need a bit level height difference.
役に立つ (0)
Q: Is the receiver flashed to get RSSI in the OSD?
尋ねた windwarrior に 2018-09-01 09:30:29
Raqtor Nah. All reviews I have seen says it isn't ..
役に立つ (0)
Q: Does it support 6s batteries?
尋ねた Fiene に 2018-07-17 08:31:54
Raqtor Nope .. 7-24V 6S is over 25V already without any power spikes and without it being HV battery
役に立つ (0)
Q: What kind of connector I need for the motors? Mine do not have Connector. Thank You!
尋ねた jrtrudel に 2018-01-09 02:05:11
Raqtor That really sucks since all motors comes with 1.25mm JST Plug. Does any motor with SH1.0mm even exist?
役に立つ (0)
Q: Did anybody tried to connect TBS unify SmartAudio on the GPS TX pad ? I need at a second UART !
尋ねた nico2nice に 2017-11-24 10:23:59
Raqtor Should work using TX6 to the VTX control and setup smart audio on UART6 in betaflight .. Have you tried it yet? .. Otherwise resource remapping should allow you to use the LED strip pad for VTX control instead.
役に立つ (0)
Q: which Uart is the esc telemetry connected to?
尋ねた Zak に 2018-01-19 07:20:31
Raqtor Hi Zak. Did you figure it out? .. I am interested in this too .. Is ESC telemetry even connected?
役に立つ (0)
Raqtor No! Only a camera. Current rating is not even documented so don't expect it to do more than that. ... 6S might be starting to trend tho I have never seen a 6S yet. If you run 6S you just need a voltage step down to preferable 9V or so
役に立つ (0)