回答
Q: well this work with happy model elrs receivers too, or just yours?
尋ねた Scotty2Quady に 2021-07-17 09:16:40
Q: Will this work with x8r receiver?
尋ねた Colin Doughty に 2021-06-19 16:02:35
Ianlaing1 no
役に立つ (0)Q: is it suitable with Jumper t-lite transmitter?
尋ねた KarloBalboa に 2021-04-19 14:37:48
Ianlaing1 if you have a 3d printer then no
役に立つ (0)
Ian The Post for the tx805 json from github will work at rated power the TX805S.. ignor the fact it say 800, its actually providing the full at 1.6w at the 4th power setting...
役に立つ (0)
Q: do you have a direct drive version (not Bowden Long range but direct drive for bondtech prusa setup)
尋ねた Paul Cole に 2019-03-27 20:40:45
Ian depending on setup with work with say a titan extruder which uses a short PTFE tube ..
役に立つ (0)
Q: where can I plug SUMD (graupner sbus) ?
尋ねた aircraftfire07 に 2019-03-06 15:49:56
BG451864550 rx3
役に立つ (0)
Q: will this work on normal r9m? like r9mm normal does?
尋ねた FTJ に 2019-09-28 11:03:36
ian.laing I was not able to use this receiver with the non access R9M module :( rather buy non access receivers for older modules.. Maybe someone else has managed to use this receiver in with r9m TX..?
役に立つ (0)
Q: Can't seem to find a termination plug that fits. Could you link one?
尋ねた rippst に 2018-11-30 04:56:44
ian.laing there appears to be no dummy 50 ohm available for these. Makes them useless. Rather buy the other antenna that have male not female like these...
役に立つ (0)
Ianlaing1 will work with any expresslrs flashed hardware.
役に立つ (1)