回答
Q: what is the total width of the three cables toghether? thank you
尋ねた niconico に 2021-09-25 02:14:38
RS2VN when 230 is visible means that you have chosen 230V input
役に立つ (0)
Q: What wire gauge should I use for the battery connector and the ESC connector?
尋ねた Christian Schneider に 2020-11-05 10:14:03
RS2VN Depends on the ESC and battery C. To be on the safe side use the same as it is on the ESC. If there is none, 14 AWG would be OK in most cases.
役に立つ (0)
RS2VN basically UART 3 is vacant and should work. I suggest that you follow the schematics and connect crossfire to UART 6. Use UART 3 for VTX (smart audio or IRC Trump).
役に立つ (0)
Q: can i know how to wire it? i burned already an FC.
尋ねた Gianluca Puntara に 2019-03-03 05:31:00
RS2VN GNDto GND (FC), 5V to 5V (FC), PB- to B- (FC), Din to LED (FC)
役に立つ (0)Q: am I correct in saying this firmware is FuryF4OSD (Diat)?
尋ねた mariomazzanti23 に 2020-02-06 05:57:09
RS2VN Yes.But I have switched back to legacy (3.5) since 4.1 behaved creasy.
役に立つ (0)
RS2VN cca 3.7 mm
役に立つ (0)