回答
Q: ¿Cual es la configuración para las retracciones optima?
尋ねた sarkat に 2021-07-07 13:48:31
Luke Direct drive is usually 1-3 mm, erring on the low side
役に立つ (0)
Luke You would need new belts and threaded rods. You would need extension cables for various sensors, and probably the hot end. You would need to compile new firmware with the new dimensions. You would need to change settings in your slicer.
役に立つ (0)
Luke From the description: 1. Object space volume is bigger than 5 x 5cm 2. Object space volume is smaller than 20.3cm x 20.3cm
役に立つ (0)
Q: is this product categorized as NAS...?
尋ねた adarnis に 2019-05-11 22:46:59
Luke Yes. It is a Network Attached Storage device.
役に立つ (0)
Luke Itcan be flashed with Marlin. However, you will need to use Marliun 2.0, not 1.9. Why? Because it is 32 bit. You'll need to use PlatformIO and Atom (or similar). Arduino IDE is for 8 bit from my understanding.ashed wiuth USB on my bench while testing, and now its installed I load the file on the the Micro SD card and do it that way.
役に立つ (0)
Luke Volts are not watts
役に立つ (0)