KY-008レーザートランスミッターモジュールAVR PIC
レビューの一部は自動翻訳されています。
but nothing too bad. what is marked with (-) should go to pwm pin as signal, middle pin should go to ground from external power source (MB102 is great for that!) and what is marked as (S) becomes + from external 5v power. once this is connected laser is nice and precise.
It's a great module but the laser itself is not really aligned with the board . It goes a little bit on the right ! That's the right way to connect it to your arduino : "S" : signal _connected to a digital pin "-" : Connected to the ground Middle pin : connected to 5 volt
良好だが、gと5vは混在している
good quality It will be tested soon
Very small and cheap module for arduino.
This is very good priced item. I suggest buying it. Delivered fast and very useful.
これらの仕事は素晴らしいし、素晴らしい味
素晴らしい小さなモジュールですが、マーキングがオフになります。 gnd は、パーマネントオン状態の場合、5v S を供給 0v に設定します。 焦点機構は、必要に応じてワイドビームに対して非常にうまく機能します。
On Arduino UNO you can plug directly into GND 13 (put the middle pin in there) and use Pin 12 for the S pin.
Now all I need is the sharks on which to put this laser beam.