CodfishCatfish CNC machines ideally use MOSFET’s to drive stepper motors for smooth movement and operation. You can’t switch relays on and off for this application. Powering, reversing and other switching can be don... もっと見る
2022-12-19 02:26:01 役に立つ (1)
p1xninja Your motors will most likely not draw more than max 2A, so 26AWG or thicker (20AWG is the thickest one). I would personally go with 24AWG, hope this helps!
2022-11-17 14:24:00 役に立つ (3)
BG123344349 I think they must be fine, they have the same functionality and characteristics as a normal Arduino UNO
2022-11-14 13:27:47 役に立つ (1)
Rassam65 Contact customer services.
2022-10-28 09:23:28 役に立つ (0)Q: I am new to woodworking so I just bought a cheap Table saw. One of those Titan table saw's for 154 euros. The tracks look very narrow. at the top but they are around 20mm x 9 - 9.5 appro on the underneath, under the narrow part.. It's almost like the slider part of the mitre Gauge would be held in place by the narrower part but I'm not sure If I have measured it correctly. I don't want to waste that もっと見る
尋ねた BG573524564 に 2022-09-03 12:51:28
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you’ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
