すべてのメッセージ

lacvo According to owner manual, there is no mention about web cam function or support on this cam

2023-01-06 04:28:34 役に立つ (0)
提出
回答 (2)

Q: Does it have screws?

尋ねた Maxgaming5577 に 2022-12-18 12:46:00

lacvo yes,camera comes with a set of screws for mounting to quad's frame

2023-01-06 04:24:13 役に立つ (0)
提出
回答 (1)

Q: Is it work for iflight cinebee?

尋ねた Jose Antonio de Paula に 2020-02-11 03:44:56

lacvo Willwork on almost any quad using betaflight, just make sure your quad FC has a free UART

2022-11-04 06:34:35 役に立つ (0)
提出
回答 (4)

lacvo 880Q can be used for the quad. Compass is a bonus but not required and indeed not recommended for quad use due to complexity of the setup

2022-11-04 06:32:42 役に立つ (0)
提出
回答 (2)

Q: Does it works with 0.15mm Nickel?

尋ねた GerasimosR に 2022-01-16 05:33:11

lacvo Works fine with higher output settings

2022-10-28 10:15:09 役に立つ (0)
提出
回答 (2)

Q: will it receive data from galileo satellites?

尋ねた BG345419817 に 2022-10-27 11:41:55

lacvo Yesit receives Galileo sats along with GPS, Glonas, Baidu

2022-10-28 10:13:45 役に立つ (0)
提出
回答 (1)

Q: Compatible with hd3?

尋ねた baboukrc に 2020-07-23 02:27:01

lacvo yes, works well with HD3

2022-10-19 03:21:47 役に立つ (0)
提出
回答 (2)

Q: can i use a Futaba S-Bus Receiver ?

尋ねた BG184855755 に 2020-08-12 01:42:45

lacvo you sure can, just make sure you set it right in iNav and wire it accordingly

2022-10-19 03:20:48 役に立つ (0)
提出
回答 (2)

Q: Problem for programming Break Fonction with V3.0 Controler ?

尋ねた FPVMAN に 2018-10-21 02:38:20

lacvo I had the ESCs for a while but have not actually use them yet. Not sure what you mean by V3.0 controller. Did you mean ESC programming card or the firmware of the ESC?

2022-10-04 01:53:13 役に立つ (0)
提出
回答 (3)

Q: What kind of battery would you combine with each kv?

尋ねた FerretChris に 2020-05-31 07:10:40

lacvo I do not use 890 or 1250 KV motors. for 1450kv, I use 6C and 2500kv I use 4C batteries. Of the 2 setups, the 6C gives extreme power and thrust compared with 4C

2022-10-04 01:49:49 役に立つ (0)
提出
回答 (2)

lacvo If I am not mistaken, the purple wire is for voltage reading from your FC to have it displayed on the camera video output so you can monitor the voltage of your flight battery. You need to solder that pin the terminal of your power supply

2022-10-04 01:46:12 役に立つ (1)
提出
回答 (2)

Q: Can we use for aomway commander ? thanks

尋ねた Fab41220 に 2019-07-20 09:55:10

lacvo May or may not fit. Check the shape of your goggles and the shape of the faceplate to see if they match

2022-09-27 09:05:38 役に立つ (0)
提出
回答 (2)