招待メールを購読することを心から歓迎します！
購読すると、製品に関する質問に答えるために電子メールで招待されます。購読すると、「役立つバッジ」も獲得できます。プライバシー設定ページでいつでも登録を解除できます。
他の人を助け、幸せになりましょう！
すべてのメッセージ
尋ねた setpoint11 に 2021-11-17 08:41:55
matthijs its an ER 11 Collet chuck, the one included, i believe is 5 or 6 mm, not sure. Before the first cut, CHECK YOUR ORIGIN, by that i mean, check where your machine has its zero set. Also check if the machine can travel the extent of your cut file. Keep in mind this machine has NO HOMING SWITCHES and wil absolutely slam into its own frame without having the slightest idea anything is wrong, so supervise it.
2021-11-17 09:44:42 役に立つ (0)回答 (4)
matthijs
25/03/2021
matthijs
25/03/2021
matthijs
25/03/2021
matthijs
25/03/2021
Q: is this pnp with ender 3 v1 ?
尋ねた pilotgenteng に 2021-01-09 11:13:03
matthijs theender 3 stock control board does not support servo outputs, wich is needed. you can, however, change your control board. But that is quite a lot of trial and error to get everything configured right
2021-03-25 07:50:22 役に立つ (1)回答 (2)
Q: can be used with lipo 3s battery ?
尋ねた Fabian Negrin に 2020-03-11 11:00:57
matthijs youcould, but i recommend using a battery protection board
2021-03-25 07:48:47 役に立つ (0)回答 (2)
Q: Is it possible to switch the keys with other switches?
尋ねた Greendragon に 2018-04-16 09:33:17
matthijs nope
2021-03-25 07:48:07 役に立つ (0)回答 (1)
matthijs it has soldering pads for either a 12 v input or a 24 v input
2021-12-21 09:16:13 役に立つ (0)