すべてのメッセージ

Q: what is the diameter of the hole required for this device?

尋ねた Coetz に 2017-12-16 08:18:04

Maminbot 46 mm or 1.8 inch exactly. So you will need a slightly larger bore with some gap as leeway. However bear in mind that the barrel does not come with a tensioning mechanism so you may need to pack it with some foam, otherwise it may rattle about. The surface cap diameter overhang is 67.8 mm or 2.67 inch.

2018-01-17 07:34:52 役に立つ (1)
提出
回答 (1)

Q: Where is the power supply?

尋ねた Glauve に 2017-12-26 12:14:40

Maminbot The 3 USB sockets are directly attached to a circuit board with a switch mode power supply. It's all contained in the tube below the surface.

2018-01-17 07:21:14 役に立つ (0)
提出
回答 (1)