招待メールを購読することを心から歓迎します！
購読すると、製品に関する質問に答えるために電子メールで招待されます。購読すると、「役立つバッジ」も獲得できます。プライバシー設定ページでいつでも登録を解除できます。
他の人を助け、幸せになりましょう！
すべてのメッセージ
Q: What is the allen bolt used for on the bottom of the tool?
尋ねた BG394087431 に 2023-02-27 02:10:56
回答 (2)
Shackman
20/01/2023
Shackman
15/01/2023
Q: will it cut lite-ply and balsa wood?
尋ねた Chris Channon に 2022-04-28 03:30:12
Shackman Yes, up to 10mm ply, 15mm balsa. I would recommend a grid for underneath, it helps with getting cleaner cut through.
2022-04-28 04:27:40 役に立つ (1)回答 (3)
尋ねた BG183717503 に 2022-01-08 07:32:15
Shackman Given the thickness of material cut a small variance shouldn't affect most projects as all cuts will be "out" the same dimension. If still a concern I would play with the gantry laser mount last LAST. Ensure the work surface is dead flat. Loosen all the base frame fasteners, adjust and retighten to try to square and plumb . Otherwise shimming a support(s) will adjust relative angle vs worksurface workpiece. If the initial assembly of the mount is WAY off back out fasteners and adjust, if necessary us thin plastic washers, mylar sheet or a shim (cut up pop cans work great for shims). When setting the laser height to workpiece us the spacer in the center off the laser not off to the side or use two spacers. Best of luck.
2022-01-08 08:19:51 役に立つ (1)回答 (3)
Q: how does it work, is there on and off?
尋ねた BG497451374 に 2021-11-17 04:37:20
Shackman Press and hold the power button for three seconds to turn on, three seconds to turn off.
2022-01-06 08:30:42 役に立つ (0)回答 (1)
Shackman
06/01/2022
Shackman
06/01/2022
Shackman
31/12/2021
Shackman
19/12/2021
Shackman
19/12/2021
Shackman
13/11/2021
Shackman
26/02/2019
Shackman
26/02/2019
Shackman
26/02/2019
Shackman
29/01/2019
Shackman
29/01/2019
Shackman It's holds the grey section and gold section together.
2023-02-27 03:43:30 役に立つ (0)