回答
Q: Is it possible to control two machines in the same room with two remote controls?
尋ねた Aksakal に 2021-11-12 04:07:33
Q: Can it measure frequency with the jaw clamp?
尋ねた Carwashmec に 2021-05-15 15:59:23
MastaH No.
役に立つ (0)
Q: Do these motors have to be soldered?
尋ねた BG542249834 に 2021-04-03 06:45:02
MastaH The wires are already connected to the motor. But you will have to solder the wire to the ESC.
役に立つ (0)
Q: is this need any flight controler
尋ねた Raj Raj に 2020-11-09 07:57:49
MastaH It depends on what you plan to do. Normally you would not use such a receiver with a flight controller. You would use it for an airplane and connect servos and motor directly. When you plan to built a multi rotor (drone) then you need a flight controller. But then this is maybe the wrong receiver.
役に立つ (0)
Q: Is it possible to use with 2s battery?
尋ねた janniskininis に 2021-01-06 04:00:29
MastaH Better not. It is a special low voltage servo. With 2s you normally need a BEC anyway to get 5V. So you can use a regular micro servo.
役に立つ (0)
MastaH yes
役に立つ (0)