回答
Q: Essa extrusora é compatível com a impressora Anycubic Kobra Go ?
尋ねた BG104611571 に 2023-01-11 14:32:42
sharptrack2 Dependson the size of the threads in your hotend, but typically they will work.
役に立つ (0)
Q: Is 8 MB PSRAM the same as 8 MB flash memory?
尋ねた JPe2 に 2023-01-05 07:08:49
sharptrack2 Yes
役に立つ (0)
Q: Hello, how much waterproof is the lazer? can I use it while swimming or diving?
尋ねた BG405757361 に 2021-11-26 14:28:27
sharptrack2 No,not waterproof.
役に立つ (0)
Q: My PCB has two solder pads marked J3. what is that for?
尋ねた Dolon に 2022-10-01 06:43:09
sharptrack2 Look at the schematic diagram that came with the kit. It shows that J3 is an extension of J1. It would allow you to daisy chain multiple boards or power 2 devices simultaneously.
役に立つ (2)
Q: is there a diagram of the connections to arduino?
尋ねた McNamara に 2022-06-01 11:25:55
sharptrack2 No,you need to have some basic understanding of what the module outputs to determine what pins to use on your Arduino board.
役に立つ (0)
Q: Is this an official Creality upgrade kit?
尋ねた Tom S に 2022-04-21 16:29:33
sharptrack2 Yes, and is easy to install. No guesswork what so ever.
役に立つ (0)
Q: how many kilograms the roll
尋ねた ID7MI1 に 2022-04-02 12:06:17
sharptrack2 The "1KG" in the description defines the total weight of filament on the roll. The "1.75MM" defines the diameter of the filament.
役に立つ (0)
sharptrack2 Probablynot. The mounting points will most likely be different. If you're handy with modifications though you could make it fit and it should work fine.
役に立つ (0)