These wheels worked for my wpl truck. 3d printed parts are not the best quality. Some of the holes were too big for the screws because of print quality. Came with all the hardware needed to install even screws. Overall good product. Would like to have 3d print files to reprint items that were not so great.

These wheels worked for my wpl truck. 3d printed parts are not the best quality. Some of the holes were too big for the screws because of print quality. Came with all the hardware needed to install even screws. Overall good product. Would like to have 3d print files to reprint items that were not so great.

These wheels worked for my wpl truck. 3d printed parts are not the best quality. Some of the holes were too big for the screws because of print quality. Came with all the hardware needed to install even screws. Overall good product. Would like to have 3d print files to reprint items that were not so great.

1. One of the 3D printed rear ear's broke off when I tried to install it. OK, checked the to see if there would be a clearances issue, if I super glued both of them on. No problem.... 2. Installed the front 3D parts, along with the front & back tracks. Releativly no problems. When I tried to test it, just made a bunch of noise. From the nylon axle hubs, just spinning inside the track hubs. I used Masking tape to wrap around the axle hubs. However, I have to remove it, to use the wheels.

1. One of the 3D printed rear ear's broke off when I tried to install it. OK, checked the to see if there would be a clearances issue, if I super glued both of them on. No problem.... 2. Installed the front 3D parts, along with the front & back tracks. Releativly no problems. When I tried to test it, just made a bunch of noise. From the nylon axle hubs, just spinning inside the track hubs. I used Masking tape to wrap around the axle hubs. However, I have to remove it, to use the wheels.

1. One of the 3D printed rear ear's broke off when I tried to install it. OK, checked the to see if there would be a clearances issue, if I super glued both of them on. No problem.... 2. Installed the front 3D parts, along with the front & back tracks. Releativly no problems. When I tried to test it, just made a bunch of noise. From the nylon axle hubs, just spinning inside the track hubs. I used Masking tape to wrap around the axle hubs. However, I have to remove it, to use the wheels.