Machifit GM4058-BLDC3650 DC 24V定格速度30RPMブラシレスワームギア付き減速機モーター
you could only use Arduino to control this thing, I tried it with raspberry pi with pi4j GPIO, and ESP8266, the reverse pin does not work on those two. for it to function properly you need to give it 5v for HIGH, and ground for LOW, note LOW IS NOT EQUALS 0V. also the pwm is not 10khz its 1khz (I tried both). the motor can do only half of the pwm resolution on both frequencies I tried.
Has build in H bridge, PWM controller and hall effect output. Can be controlled via arduino.
funciono perfectamente solo un cable venía cortó ya que no estaba empaquetado con protección
Good engine1
ele não vem o controlador ; melhor comprar junto