A nice little camera, very useful. The thermal image is well superimposed on the visible image, the 32x24 sensor does a good job, and the program interpolates the results to cover the visual image. The measured temperatures are within 1-2 C of the ones shown by a thermometer at the same place, so the precision is adequate for this price. The only slight annoyance is that there are always 3 crosshairs on the thermal image, and two of them jump around finding a low temp and high temp spot. That would be nice to be able to turn on/off, as sometimes it is desired, but other times just the temp of the center would be needed. The auto-scaling of the temp colors is at times annoying, especially if there is one hot spot, then all the others become blue. It would be nice to have a menu to toggle these, the 3 buttons would be enough to navigate in it. That would be a good further development. (even a firmware upgrade?)

A nice little camera, very useful. The thermal image is well superimposed on the visible image, the 32x24 sensor does a good job, and the program interpolates the results to cover the visual image. The measured temperatures are within 1-2 C of the ones shown by a thermometer at the same place, so the precision is adequate for this price. The only slight annoyance is that there are always 3 crosshairs on the thermal image, and two of them jump around finding a low temp and high temp spot. That would be nice to be able to turn on/off, as sometimes it is desired, but other times just the temp of the center would be needed. The auto-scaling of the temp colors is at times annoying, especially if there is one hot spot, then all the others become blue. It would be nice to have a menu to toggle these, the 3 buttons would be enough to navigate in it. That would be a good further development. (even a firmware upgrade?)

A nice little camera, very useful. The thermal image is well superimposed on the visible image, the 32x24 sensor does a good job, and the program interpolates the results to cover the visual image. The measured temperatures are within 1-2 C of the ones shown by a thermometer at the same place, so the precision is adequate for this price. The only slight annoyance is that there are always 3 crosshairs on the thermal image, and two of them jump around finding a low temp and high temp spot. That would be nice to be able to turn on/off, as sometimes it is desired, but other times just the temp of the center would be needed. The auto-scaling of the temp colors is at times annoying, especially if there is one hot spot, then all the others become blue. It would be nice to have a menu to toggle these, the 3 buttons would be enough to navigate in it. That would be a good further development. (even a firmware upgrade?)