RC飛行機用HJデジタルサーボテスター/ESC一貫性テスター
レビューの一部は自動翻訳されています。
出力周波数を可変する可能性があります。アナログの場合は3つの周波数50HZ、デジタルサーボの場合は125HZと250HZ
Funziona molto bene, il display è bello luminoso, e indica la frequenza di segnale uscita verso il servo. molto utile per posizionare il centro dei servocomandi senza usare la ricevente. facile da usare
There are lots of these on the market at wildly different price points. You don't really get what you pay for: this is one of the best I've had yet one of the cheapest. Pros: Cheap Bright display 3 modes Adjustment knob feels precise and is easy to operate Cons: A bit of jitter sometimes (sends a wavering signal to servo and displayed pulse width also jitters) - but most testers do this after a while, this one ain't bad Polarity label is at right angle to pins, making it ambiguous - but you can look for the Futaba notch that indicates the signal side Plugging in four servos will be hard because pin pitch is a bit too narrow - common problem We'll see if the jitter gets so bad I have to replace it. At this price that's tolerable.
The tester works as expected. It offers three modes (manual control, center and range sweep). The pulse with is adjustable within the range of 800 to 2200ms. It also has the possibility of selecting the pulse frequency: 50Hz, 125Hz and 250Hz.
良いアイテムは非常に一貫性のある安い!!!
В работе не проверял, пока не не чем. На вид собрано нормально. Довольно компактный, размер 75х37мм. In the work did not check, not yet than. In appearance collected normally. Quite compact, size 75x37mm.
Пришел быстро. Сборка качественная. В качестве регулятора - энкодер. Плюс это или минус - кому как. Я доволен. Рекомендую!
хорошее качество в работе ещё не проверял
Excelente probador de servos funciona perfectamente y tiene un precio muy asequible genial
素敵で小さい