This UBEC looks good and is small and light. I bench-tested it and it works as expected: at 4Amps output decreases to 4.86V (-2,8%). At 5 Amps Vout goes down to 4,8 (-4%) but it is still stable. Above 5 voltage drops fast. Overload protection works well. Under charge the heat is reasonable, but I recommend to place it in a ventilated place. At the end. I think it can be placed in models with 4+ servos and give a good service.

This UBEC looks good and is small and light. I bench-tested it and it works as expected: at 4Amps output decreases to 4.86V (-2,8%). At 5 Amps Vout goes down to 4,8 (-4%) but it is still stable. Above 5 voltage drops fast. Overload protection works well. Under charge the heat is reasonable, but I recommend to place it in a ventilated place. At the end. I think it can be placed in models with 4+ servos and give a good service.

This UBEC looks good and is small and light. I bench-tested it and it works as expected: at 4Amps output decreases to 4.86V (-2,8%). At 5 Amps Vout goes down to 4,8 (-4%) but it is still stable. Above 5 voltage drops fast. Overload protection works well. Under charge the heat is reasonable, but I recommend to place it in a ventilated place. At the end. I think it can be placed in models with 4+ servos and give a good service.

2A負荷でリップルを約2mV測定したクリーンな出力で、1Aで同じです。2A連続では、ほとんど暖まりません。 出力レギュレーション、低ノイズ、連続電流供給について、私がテストした最高のBECの1つです。

Nice clean output, measured about 2mV of ripple at 2A load, same at 1A. With 2A continuous it barely gets warm. One of the best BEC's I've tested for output regulation, low noise and continuous current delivery.

2A負荷でリップルを約2mV測定したクリーンな出力で、1Aで同じです。2A連続では、ほとんど暖まりません。 出力レギュレーション、低ノイズ、連続電流供給について、私がテストした最高のBECの1つです。