DS18B20防水デジタル温度温度センサープローブ1M 2M 3M 5M 10M 15M
The sensor arrived well wrapped, the delivery was relatively agile (about a month). I managed to use 2 of the 6. So far everything is fine, I'm satisfied.
Very fast shipping. Everything is good. Thanks!
it arrived in half of estimated time and very well packed. I didn’t have time to test yet, but so far so good. good price, fast and safe delivered.
Good for diy, pool temperature monitor.
Works perfect, used to create sensor for the fridge
easy to use in arduino IDE with all the data and libs on the internet.
La sonda funziona perfettamente per la misura della temperature del mio acquario con arduino. Sensore digitale con risoluzione programmabile da 9 a 12 bit. (la lettura in 12bit richiede circa 600ms). Interfaccia 1wire che consente la comunicazione attraverso 1 solo pin di arduino. (Ffilo giallo DATA) Rivestimento della sonda flessibile e resistente. Consiglio l'acquisto per i vostri progetti.
I've bought two of these probes to check the temperature in the room where computers are. They're connected to a Raspberry PI B+ (GPIO4 + 4K7 Ohm resistor) and it works fine. They're not very accurate (0,4° C between the 2 probes) but it's enough to get an idea of the temperature.
works well. Think to use one_wire scanner (like this https://www.carnetdumaker.net/articles/faire-un-scanneur-de-bus-1-wire-avec-une-carte-arduino/) to obtain the address of the temperature sensor (sensor will be easer to use)
Temperatursensor DS18B20 funktioniert am ESP8266 perfekt