DIYミニZ車の双方向30Aミニチュアブラシ付きESCブレーキ付き
レビューの一部は自動翻訳されています。
The real thing doesn't look like photos in description. At first I saw the LS-L4015-D on the board and I thought oh no, I had this before and it was crap. As it turned out this is V2 board and it's a joy to use. Throttle is smooth and low rev is working brilliantly. Centre point of this ESC is blinking LED, don't worry about it.
I bought several esc's this size from several different stores to test out.I like this 30a esc from Banggood the best, it worked the way it should by simply plugging in.I will be using more of these in the future.The other esc's I've tried all functioned backwards.Even after reversing my transmitter I could never get them to function properly using reverse to drive forward.If your looking for a esc to control a small motor then look no further this Miniz esc has been great for me.
到着 - ブレーキがありません 両方の方向で試したが、ブレーキはまったく適用されず、完全な前方から完全な逆方向にまっすぐに、他の方法と同じように 非常に強力なギアボックスと差分がなければ、車に良いことはありません
I just cannot seem to find the neutral position on this ESC. The ones i received were slightly different than pictured here. It is wrapped with a clear plastic for protection and has a capacitor on the battery leads. It is possible there is some other differences internally as I just cant find the neutral position as per the instructions (red led off) no matter how much i trim the throttle. I have tried another receiver as well as another one of these ESC but same results.The ESC functions well otherwise but i am very frustrated with this neutral position issue. I have posted the question regarding this on banggood but have yet to receive a response. Does anyone else out there have this issue? If not did yours come without the clear plastic wrap and capacitor as pictured or with the plastic wrap and capacitor as mine did? I would still recommend as i am sure there is a way to achieve neutral once proper instructions are available.
非常に良い製品... 彼らは超高速に到着した
Produto excelente. É bastante macio com alta aderência. A distância da última foto é de 23,5mm
チュード ok
The ESC is great; 30 amps, small form factor and can definitely fit in a Kyosho Mini-Z that is to be modded as is on my project here. However, do NOTE/Warning that this requires PPM signal and does not work with my Futaba 2PL 2.4 GhZ (2009 model) transmitter and receiver, but works perfectly with my Spektrum DX8. It would be unfair to lower the review score of this product due to my own issue with my transmitter but overall, this is great for any 1/28 or 1/24 car conversion/mod for Model kit cars or Mini-Z cars and etc that are brushed.
It was great in my project, worked perfectly, it was very easy to install just by following the connection patterns, it was not necessary to use manual. Highly recommend.
I got it to modify toy-grade RC to full proportional. 30A is plenty. It works with 4AA batteries as well. If the calibration instruction above is confusing (which I find that it is) here is a simple one. - Turn it on - The neutral position is when the red light is off - If red light appears use the throttle trim on your transmitter until it goes off