配送先 United Kingdom , USD

お客様レビュー

4.99 から 5
レビューを書きます。
  • すべてのレビュー (71)
  • 画像 (7)
  • ビデオ (0)
  • オールスター
    • オールスター(71)
    • 5スター(70)
    • 4スター(1)
    • 3スター(0)
    • 2スター(0)
    • 1スター(0)
並び替え:
トップレビュー
  • トップレビュー
  • 最も役立つ
  • 新着商品
    • 全体:
    • 価格:
    • 数量:
    • 外観:

    2019-04-11 09:11:55

    Works well on Ender 3, BUT if your control board has capacitor C7 installed (see photo) then you must remove it, or the very short duration Z-stop signal from BLTouch will not be detected and the extruder will just crash into the print bed when it auto-homes. This is a known issue with BLTouch and the latest Ender 3 control boards leave out C7. To refit the Ender 3/Pro cover and fan, you need to bend the four pins on the adapter PCB so that the 4-way header from BLTouch is horizontal. Versions of

    コメント
    • 全体:
    • 価格:
    • 数量:
    • 外観:

    2019-06-05 08:42:56

    Quick and easy install product as described v3 version totally happy with it

    コメント
    • 全体:
    • 価格:
    • 数量:
    • 外観:

    2019-08-28 15:28:20

    very nice

    コメント
    • 全体:
    • 価格:
    • 数量:
    • 外観:

    2019-07-26 01:35:22

    Easy to use

    コメント
    • 全体:
    • 価格:
    • 数量:
    • 外観:

    2019-05-29 08:16:19

    very good

    コメント
    • 全体:
    • 価格:
    • 数量:
    • 外観:

    2019-05-24 11:05:23

    Bltouch v3 has many solutions to install properly. A video by teachingtech in yt is the best and most comprehensive video on installation. Only down side it the need to bend the leads to make it fit in the motherboard box. Even with it bent, it may be a very tight fit. Aside from that, the wire length is long enough and easy to connect. I did not use the included isp-usb connector but the wire is nice to use if you need to extend the wire length of the LCD screen. Teaching tech also has a video if

    コメント
    • 全体:
    • 価格:
    • 数量:
    • 外観:

    2019-05-05 09:46:24

    good product but it is the new series of BLTOUCH (v3 pre april). This V3 has little complicated settings, while buying research first about V3 bltouch(there are two v3 versions also pre april or after april)

    コメント
    • 全体:
    • 価格:
    • 数量:
    • 外観:

    2019-05-22 19:15:17

    It is works fine with ender3 pro.

    コメント (1)
  1 2 3 4 5 6 7 8 9 10  

あなたにおすすめの商品

満足度調査

アプリをダウンロードして1件目の注文は$100 offにすることはお楽しみください