3Dプリンタ用のRamps 1.6ボードをRamps 1.5 4層PCB制御パネルメインボードに基づいて5個のDRV8825ドライバーでアップグレード
レビューの一部は自動翻訳されています。
Except for having a hard time finding official specs and documentation, this seems quite robust. Dial in your vref before using because mine were WAY off the recommended 500mv (by a factor of 3 or 4). To use with 24v systems, remove D1 and run the output of a buck regulator to the right pad where D1 was. Dial the buck to around 6 or 7 volts to feed the Mega board's regulator and everything works perfectly.
迅速な配達 良好な状態
あなたのランプボードのための素晴らしいアップグレード! RAMPS 1.4 よりもはるかに優れた熱管理機能です。 MOSFETは良好でクールです。
完璧に感謝します 素晴らしい作品です
ボードは素晴らしいです!!!!
very nice product fast delivery I recommend to all
look good pins bent a bit but iets working
Purchased for my 3d printer needed a bit upgrade!
Vše v pořádku doručeno celkem rychlá doprava
tip top